Switch 7700 Command reference Guide, v2.0

244 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
Parameter
None
Description
Use the memory auto-establish enable command to allow the routing protocol
connection that is forcibly disconnected to recover automatically when the idle
memory of the Ethernet switch reaches this value.
By default, when the idle memory of the Ethernet switch recovers to a safety
value, connections of all the routing protocols will always recover (when the idle
memory of the Ethernet switch reduces to a lower limit, the connection will be
disconnected forcibly).
Related commands: memory auto-establish disable, memory { safety |
limit }
, display memory limit.
Example
Enable memory resume of the current Ethernet switch and recover connections of
all the protocols automatically.
[SW7700]memory auto-establish enable
[SW7700]
%4/10/2003 17:47:3-RM-5-S1-RTLOG:You have changed the model of
connection
memory { safety | limit } Syntax
memory { safety safety_value | limit limit_value }*
memory default
View
System view
Parameter
safety safety_value: The safety value of the Ethernet switch idle memory, in
the unit of Mbytes. Its value range depends on the idle memory of the active
Ethernet switch. The default value is 4Mbytes.
limit limit_value: The lower limit of the Ethernet switch idle memory, in the
unit of Mbytes. Its value range depends on the idle memory of the active Ethernet
switch. The default value is 2Mbytes.
default: Set the safety value and lower limit of the Ethernet switch idle memory
to the default value.
Description
■ Use the memory limit limit_value command to configure the lower limit of
the Ethernet switch idle memory. When the idle memory of the Ethernet switch
is less than this limit, all the routing protocol connections will be disconnected
forcibly. The
limit_value in the command must be less than the current idle
memory safety value, and otherwise the configuration will fail.