Switch 7700 Command reference Guide, v2.0

264 CHAPTER 6: USING MULTICAST PROTOCOL COMMANDS
display pim
routing-table
Syntax
display pim routing-table [ { { *g [ group-address [ mask {
mask-length | mask } ] ] | **rp [ rp-address [ mask { mask-length |
mask } ] ] } | { group-address [ mask { mask-length | mask } ] |
source-address [ mask { mask-length | mask } ] } * } |
incoming-interface { interface-type interface-num | interface-name |
null } | { dense-mode | sparse-mode } ] *
View
All views
Parameter
**rp: (*, *, RP) route entry.
*g: (*, G) route entry.
group-address: Address of the multicast group.
source-address: IP address of the multicast source.
incoming-interface: Router entry with the specified incoming interface.
Description
Use the display pim routing-table to view the contents of the PIM multicast
routing table.
Related command: display multicast routing-table.
Example
View the contents of the PIM multicast routing table on the router.
<SW7700>display pim routing-table
PIMSM Routing Table
Total 0 (*,*,RP), 0 (*,G), 2 (S,G)
(192.168.1.2, 224.2.178.130),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
(192.168.1.2, 224.2.181.90),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
Total 2 entries listed
Uptime Time passed since the multicast group has been discovered
Expires Specifies when the member will be removed from the group
Table 21 Output description about PIM neighbors