Switch 7700 Command reference Guide, v2.0

302 CHAPTER 8: USING STP COMMANDS
■ stp
■ stp bpdu-protection
■ stp bridge-diameter
■ stp bridge-priority
■ stp edged-port
■ stp instance cost
■ stp instance port priority
■ stp instance root primary
■ stp instance root secondary
■ stp interface
■ stp interface edged-port
■ stp interface instance cost
■ stp interface instance port priority
■ stp interface loop-protection
■ stp interface mcheck
■ stp interface point-to-point
■ stp interface root-protection
■ stp interface transit-limit
■ stp loop-protection
■ stp max-hops
■ stp mcheck
■ stp mode
■ stp point-to-point
■ stp region-configuration
■ stp root-protection
■ stp timer forward-delay
■ stp timer hello
■ stp timer max-age
■ stp transit-limit
■ vlan-mapping modulo
RSTP Configuration
Commands
This section describes how to use the Rapid Spanning Tree Protocol (RSTP)
configuration commands on the Switch 7700.
Cisco products adopt private key to encrypt the configuration digest of MSTP,
therefore the link between Cisco products and the Switch 7700 defaults to RSTP.
display stp Syntax
display stp [ interface interface_list ]