Switch 7700 Command reference Guide, v2.0

32 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
View
User interface view
Parameter
minutes: Enter the number of minutes you want to allow a user interface to
remain idle before it is disconnected. This can be in the range 0 to 35791.
seconds: Enter the number of seconds in addition to the number of minutes.
Optional.
Description
■ Use the idle-timeout command to configure the amount of time you want to
allow a user interface to remain idle before it is disconnected.
■ Use the undo idle-timeout command to restore the default idle-timeout. By
default, idle-timeout is set to 10 minutes.
To disable idle timeout, set the idle-timeout value to 0.
Example
To configure the timeout value to 1 minute on the AUX user interface, enter the
following:
[SW7700-ui-aux0]idle-timeout 1
lock Syntax
lock
View
User View
Parameter
None
Description
Use the lock command to lock the current user interface and prevent
unauthorized users from accessing it. An authorized user must enter a valid
password to access the interface.
Example
To lock the current user interface, enter the following:
<SW7700>lock
Password: xxxx
Again: xxxx
modem Syntax
modem { call-in | both }
undo modem { call-in | both }