Switch 7700 Command reference Guide, v2.0

320 CHAPTER 8: USING STP COMMANDS
A VLAN cannot be mapped to different instances at the same time. The latter
configured association will replace the former one.
Related commands: region-name, revision-level, check
region-configuration
, vlan-mapping modulo, active
region-configuration
.
Example
Map VLAN 2 to STI 1.
[SW7700-mst-region]instance 1 vlan 2
region-name Syntax
region-name name
undo region-name
View
MST region view
Parameter
name: Specifies the MST region name of the switch with a character string not
exceeding 32 bytes.
Description
■ Use the region-name command to configure the MST region name of a switch.
■ Use the undo region-name command to restore the default MST region name.
By default, the MST region name of the switch is the first MAC address in
hexadecimal notation.
The switch region name, together with VLAN mapping table of the MST region
and MSTP revision level, is used for determining the region to which the switch
belongs.
Related commands: instance, revision-level, check region-configuration,
vlan-mapping modulo, active region-configuration.
Example
Set the MST region name of the switch as 3Com.
[SW7700-mst-region]region-name 3Com
reset stp Syntax
reset stp [ interface interface-list ]
View
User view