Switch 7700 Command reference Guide, v2.0

352 CHAPTER 9: USING AAA AND RADIUS COMMANDS
Example
Configure 802.1x user to use PAP authentication
[SW7700]dot1x authentication-method pap
dot1x dhcp-launch Syntax
dot1x dhcp-launch
undo dot1x dhcp-launch
View
System view
Parameter
None
Description
■ Use the dot1x dhcp-launch command to configure whether 802.1x enables
the Ethernet switch to launch the user ID authentication when the supplicant
runs DHCP and applies for dynamic IP addresses.
■ Use the undo dot1x dhcp-launch command to disable DHCP to launch ID
authentication on the supplicant.
By default, DHCP is not allowed launching user ID authentication.
If the supplicant is a Windows XP user, you should enable this command before
performing 802.1x authentication.
Related command: dot1x.
Example
Enable to launch ID authentication for the supplicant when he runs DHCP and
applies for dynamic IP addresses.
[SW7700]dot1x dhcp-launch
dot1x max-user Syntax
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
View
System view
Ethernet port view
Parameter
user-number: Specifies the limit to the amount of supplicants on the port,
ranging from 1 to 1024.
By default, the maximum user number is 1024.