Switch 7700 Command reference Guide, v2.0

802.1x Configuration Commands 359
Related command: display dot1x.
Example
Set the Authentication Server timeout timer is 150s.
[SW7700]dot1x timer server-timeout 150
dot1x timer
handshake-period
Syntax
dot1x timer handshake-period interval
undo dot1x timer handshake-period
View
system view
Parameter
interval: handshake period, range from 1 to 1024, unit in second.
Description
■ Use the dot1x timer handshake-period command to set the handshake
period of 802.1x.
■ Use the undo dot1x timer handshake-period command to restore the
handshake period to default value.
By default, handshake period is 15s.
After setting handshake-period, system will send the handshake packet by the
period
. Suppose the dot1x retry time is configured as N, the system will consider
the user having logged off and set the user as logoff state if system doesn’t receive
the response from user for consecutive N times.
Example
Set the handshake period of 802.1x to 200 seconds.
[SW7700]dot1x timer handshake-period 200
reset dot1x statistics Syntax
reset dot1x statistics [ interface interface-list ]
View
User view
Parameter
interface interface-list: Ethernet port list including several Ethernet ports.
interface-list = { interface-num [ to interface-num ] } & < 1-10 >.
interface-num specifies a single Ethernet port in the format port-num = {
interface-type interface-num | interface-name }, where interface-type specifies the
port type, interface-num specifies the port number and interface-name specifies
the port name. For the respective meanings and value ranges, read the Parameter
of the Port Configuration section.