Switch 7700 Command reference Guide, v2.0

RADIUS Protocol Configuration Commands 379
Related commands: key, radius scheme, state.
Example
Set the IP address of the primary accounting server of RADIUS server group,
“3Com”, to 10.110.1.2 and the UDP port 1813 to provide RADIUS accounting
service.
[SW7700-radius-3Com]primary accounting 10.110.1.2 1813
primary authentication Syntax
primary authentication ip-address [ port-number ]
undo primary authentication
View
RADIUS server group view
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
the primary authentication/authorization is at 0.0.0.0.
port-number: Specifies UDP port number. ranging from 1 to 65535. By default,
the UDP port for authentication/authorization service is 1812 .
Description
■ Use the primary authentication command to configure the IP address and
port number for the primary RADIUS authentication/authorization.
■ Use the undo primary authentication command to restore the default IP
address and port number of the primary RADIUS authentication/authorization.
After creating a RADIUS server group, you are supposed to set IP addresses and
UDP port numbers for the RADIUS servers, including primary/second
authentication/authorization servers and accounting servers. In real networking
environments, the above parameters shall be set according to the specific
requirements. However, at least you have to set one authentication/authorization
server and an accounting server. Besides, ensure that the RADIUS service port
settings on the Ethernet switch is consistent with the port settings on the RADIUS
server.
Related commands: key, radius scheme, state.
Example
Set the IP address of the primary authentication/authorization server of RADIUS
server group, “3Com”, to 10.110.1.1 and the UDP port 1812 to provide RADIUS
authentication/authorization service.
[SW7700-radius-3Com]primary authentication auth 10.110.1.1 1812
radius scheme Syntax
radius scheme radius-server-name
undo radius scheme radius-server-name