Switch 7700 Command reference Guide, v2.0

380 CHAPTER 9: USING AAA AND RADIUS COMMANDS
View
System view
Parameter
radius-server-name: Specifies the Radius server name with a character string
not exceeding 32 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”.
Description
■ Use the radius scheme command to configure a RADIUS server group and
enter its view.
■ Use the undo radius scheme command to cancel the specified RADIUS server
group.
By default, there is RADIUS server group named “default” has been created in the
system. The attributes of “default” are all default values.
RADIUS protocol configuration is performed on a per-RADIUS-server-group basis.
Every RADIUS server group shall at least have the specified IP address and UDP
port number of the RADIUS authentication/authorization/accounting server and
some necessary parameters exchanged with the RADIUS client end (switch
system). So it is necessary to create the RADIUS server group and enter its view
before performing other RADIUS protocol configurations.
A RADIUS server group can be used by several ISP domains at the same time.
Although undo radius scheme can remove a specified RADIUS server group.
However, the default one cannot be removed. Note that a serer group currently in
use by the online user cannot be removed.
Related commands: key, retry realtime-accounting, radius-scheme, timer
realtime-accounting
, stop-accounting-buffer enable, retry
stop-accounting
, server-type, state, user-name-format, retry, display
radius
, display radius statistics.
Example
Create a RADIUS server group named “3Com” and enters its view.
[SW7700]radius scheme 3Com
[SW7700-radius-3Com]
reset
stop-accounting-buffer
Syntax
reset stop-accounting-buffer { radius-scheme radius-scheme-name |
session-id session-id | time-range start-time stop-time | user-name
user-name }
View
User view
Parameter
radius-scheme radius-server-name: Configures to delete the stopping
accounting requests from the buffer according to the specified RADIUS server