Switch 7700 Command reference Guide, v2.0

RADIUS Protocol Configuration Commands 387
View
RADIUS server group view
Parameter
None
Description
■ Use the stop-accounting-buffer enable command to configure to save the
stopping accounting requests without response in the switch system buffer.
■ Use the undo stop-accounting-buffer enable command to cancel the
function of saving the stopping accounting requests without response in the
switch system buffer.
By default, enable to save the stopping accounting requests in the buffer.
Because the stopping accounting request concerns account balance and will affect
the amount of charge, which is very important for both the user and ISP, NAS shall
make its best effort to send the message to RADIUS accounting server.
Accordingly, if the message from the switch to RADIUS accounting server has not
been responded, the switch shall save it in the local buffer and retransmit it until
the server responds or discard the messages after transmitting for specified times.
Related commands: reset stop-accounting-buffer, radius scheme, display
stop-accounting-buffer
.
Example
Indicate that, for the server “3Com” in the RADIUS server group, the switch
system will save the stopping accounting request packets in the buffer
[SW7700-radius-3Com]stop-accounting-buffer enable
timer Syntax
timer second
undo timer
View
RADIUS server group view
Parameter
second: RADIUS server response timeout timer, ranging from 1 to 10 and
measured in seconds. By default, the value is 3.
Description
■ Use the timer command to configure RADIUS server response timer.
■ Use the undo timer command to restore the default value of the timer.
After RADIUS (authentication/authorization or accounting) request packet has
been transmitted for a period of time, if NAS has not received the response from
RADIUS server, it has to retransmit the message to guarantee RADIUS service for
the user. The period taken is called RADIUS server response timeout time, which