Switch 7700 Command reference Guide, v2.0

Logging in Commands 39
■ You cannot use this command on the current user interface.
■ You are asked to confirm the command.
Example
To disable the terminal service on the VTY user interfaces 0 to 4, enter the
following from another user interface:
[SW7700]user-interface vty 0 4
[SW7700-ui-vty0-4]undo shell
The following message will be displayed on the Telnet terminal after login:
Connection to host lost.
speed Syntax
speed speed-value
undo speed
View
User interface view
Parameter
speed-value: Specify the transmission rate on the AUX (Console) port in bits per
second (b/s). This can be any of the following values: 300, 600, 1200, 4800, 9600,
19200, 38400, 57600, 115200 or 4096000.
The default rate is 9600 b/s.
Description
Use the speed command to configure the transmission rate on the AUX (Console)
port.
Use the undo speed command to restore the default rate.
This command can only be performed in AUX user interface view.
Example
To configure the transmission speed on the AUX (Console) port as 9600 b/s, enter
the following:
[SW7700]speed 9600
stopbits Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
View
User interface view
Parameter
1: Sets the stop bits to 1.