Switch 7700 Command reference Guide, v2.0

396 CHAPTER 10: USING RELIABILITY COMMANDS
■ Use the undo vrrp vrid priority command to clear the virtual router
priority.
The priority decides the status of a switch in the virtual router. A higher-priority
switch is more likely to be a Master. Priority 0 is reserved for a special purpose. 255
is reserved for the IP address owner. The priority of the IP address owner is always
255 and cannot be modified.
Example
Set the virtual router priority on VLAN-interface2.
[SW7700-vlan-interface2]vrrp vrid 1 priority 150
vrrp vrid timer Syntax
vrrp vrid virtual-router-ID timer advertise adver-interval
undo vrrp vrid virtual-router-ID timer advertise
View
VLAN interface view.
Parameter
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.
adver-interval: VRRP packet interval of the Master in the virtual router in
seconds, ranging from 1 to 255; By default, the value is 3s.
Description
■ Use the vrrp vrid timer command to set the virtual router timer.
■ Use the undo vrrp vrid timer command to clear the virtual router timer.
This command is used to set the VRRP packet interval of the Master in the virtual
router. You should set the identical timer value for the switches in the same virtual
router to avoid improper configuration.
Example
Configure the Master to transmit VRRP packets every 15 seconds.
[SW7700-vlan-interface2]vrrp vrid 1 timer advertise 15
vrrp vrid track Syntax
vrrp vrid virtual-router-ID track vlan-interface interface-num [
reduced value-reduced ]
undo vrrp vrid virtual-router-ID track [ interface-name ]
View
VLAN interface view.
Parameter
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.