Switch 7700 Command reference Guide, v2.0

414 CHAPTER 11: USING SYSTEM MANAGEMENT COMMANDS
Display the information of all the files (including the deleted ones) in the current
directory.
<SW7700>dir /all
Directory of *
0 -rw- 50 Jul 12 2001 20:34:19 sample.bak
1 -rw- 595 Jul 12 2001 20:13:19 test.txt
16125952 bytes total (13972480 bytes free)
Configuration File
Management
Commands
This section describes the commands you can use to manage the configuration
files on your Switch 7700.
reset
saved-configuration
Syntax
reset saved-configuration
View
User view
Parameter
None
Description
Using the reset saved-configuration command, you can erase configuration
files from the flash memory of the Ethernet Switch.
Perform this command with cautious. It is suggested to consult technical support
personnel first.
Generally, this command is used in the following situations:
■ After upgrade of software, configuration files in flash memory may not match
the new version's software. Perform
reset saved-configuration command
to erase the old configuration files.
■ If a used Ethernet Switch is applied to the new circumstance and the original
configuration files cannot meet the new requirements, the Ethernet Switch
should be configured again. Erase the original configuration files for
reconfiguration.
If the configuration files do not exist in the flash memory when Ethernet Switch is
electrified and initialized, it will enter setup switch view automatically.
Related commands: save, display current-configuration, display
saved-configuration
.
Example
Erase the configuration files from the flash memory of Ethernet Switch.
<SW7700>reset saved-configuration
This will erase the configuration in the flash memory.
The router configurations will be erased to reconfigure.
Are you sure?[Y/N]y