Switch 7700 Command reference Guide, v2.0

FTP Client Commands 419
level level: Enter the user level of the Telnet user, in the range 0 to 3. The
default is 3. Optional.
ftp: Specifies the user’s service type as FTP.
ftp-directory directory: Enter an FTP directory, up to 64 characters in length.
Optional.
lan-access: Specifies the user’s service type as LAN access, which refers mainly to
Ethernet users.
Description
Using the service-type command, you can configure a service type for a
particular user.
Using the service-type command, you can cancel the currently configured
servcie service type for a particular user.
Example
To configure a service type of LAN access for the user 3Com1, enter the following:
[SW7700-user-3Com1]service-type lan-access
FTP Client Commands This section describes the File Transfer Protocol (FTP) Client commands on your
Switch 7700.
ascii Syntax
ascii
View
FTP Client view
Parameter
None
Description
Using the ascii command, you can configure data transmission mode as ASCII
mode.
By default, the file transmission mode is ASCII mode.
Perform this command if the user needs to change the file transmission mode to
default mode.
Example
Configure to transmit data in the ASCII mode.
[ftp]ascii
200 Type set to A.
binary Syntax
binary