Switch 7700 Command reference Guide, v2.0

42 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
Example
To configure the hostname of the Switch 7700 to 3Com, enter the following:
[SW7700]sysname 3Com
[3Com]
system-view Syntax
system-view
View
User view
Parameter
None
Description
Enter system-view to enter the system view from the user view.
Related commands: quit, return.
Example
To enter system view from user view, enter the following:
<SW7700>system-view
Enter system view, return user view with Ctrl+Z.
[SW7700]
telnet Syntax
telnet host_ip_address [ service_port ]
View
User view
Parameter
host_ip_address: Enter the IP address or the host name of the remote Switch. If
you enter the host name, the Switch must be set to static resolution.
service_port: Designates the management port on the remote Switch, in the
range 0 to 65535. Optional.
Description
Use the telnet command to log in to another Ethernet switch from the current
switch via Telnet for remote management. To terminate the Telnet logon, press
Ctrl+].
If you do not specify a service_port, the default Telnet port number of 23 is
used.
Related command: display tcp status.