Switch 7700 Command reference Guide, v2.0

430 CHAPTER 11: USING SYSTEM MANAGEMENT COMMANDS
MAC Address Table
Management
Commands
This section describes the commands you can use to manage the MAC Address
Table on your Switch 7700.
display mac-address
learning
Syntax
display mac-address learning [ interface-type interface-num |
interface-name ]
View
All views
Parameter
interface-type: Specify the interface type.
interface-num: Specify the interface number.
interface-name: Specify the interface name.
For details about the interface-type, interface-num and interface-name
parameters, refer to the Port Configuration in this manual.
Description
Using the display mac-address learning command, you can display if the
switch or a port can learn the MAC address.
Example
Show the state of address learning on Ethernet1/0/1.
[SW7700-Ethernet1/0/1]display mac-address learning
mac-address learning status of the switch: enable
PortName Learning Status
Ethernet1/0/1 enable
display mac-address
aging-time
Syntax
display mac-address aging-time
View
All views
Parameter
None
Description
Using the display mac-address aging-time command, you can display the
aging time of the dynamic entry in the MAC address table.
For the related commands, see mac-address, mac-address timer, display
mac-address
.