Switch 7700 Command reference Guide, v2.0

44 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
Description
■ Use the user privilege level level command to configure the command
level that a user can access from the specified user interface. The user can use
all the available commands at this command level.
■ Use the undo user privilege level command to restore the default
command level. By default, a user can access all commands at Level 3 after
logging in through the AUX user interface, and all commands at Level 0 after
logging in through a VTY user interface.
Example
To configure a user to access command level 0 after logging in from the VTY 0
user interface, enter the following:
[SW7700]user privilege level 0
When the user Telnets from the VTY 0 user interface to the switch, the terminal
displays commands at level 0, as shown below:
<SW7700>?
User view commands:
ping Ping function
quit Exit from current command view
super Enter the command workspace with specified user priority
level
telnet Establish one TELNET connection
tracert Trace route function