Switch 7700 Command reference Guide, v2.0

Log Commands 457
If the information in the current log/trap buffer is less than the specified sizeval,
display the actual log/trap information.
For the related commands, see info-center enable, info-center loghost,
info-center logbuffer, info-center console channel, info-center
monitor channel
.
Example
Show the system log information.
<SW7700>display info-center
Information Center: enabled
Info-center loghost:
Console:
channel number : 0 , channel name : console
Monitor:
channel number : 1 , channel name : monitor
SNMP Agent:
channel number : 5 , channel name : snmpagent
Logging buffer:
enabled,max buffer size 1024, current buffer size 256,
current messages 3, channel no : 4 , channel name : logbuf
dropped messages 0, overwrote messages 0
Trapping buffer:
enabled,max buffer size 1024, current buffer size 256,
current messages 1, channel number:3, channel name:trapbuf
dropped messages 0, overwrote messages 0
Information timestamp setting:
log - datetime, trap - datetime, debugging - uptime
Sent messages = 5, Received messages = 5
info-center console
channel
Syntax
info-center console channel { channel-number | channel-name }
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specify the channel name.
Description
Using the info-center console channel command, you can configure the
channel through which the log information is output to the console.
By default, Ethernet switches do not output log information to the console.
This command takes effect only after system logging is started.
For the related commands, see info-center enable, display info-center.