Switch 7700 Command reference Guide, v2.0

Ethernet Port Configuration Commands 47
The M-Ethernet interface is always set to 0/0/0.
You can use the interface_name at this command. This is made up of
interface_type and interface_number parameters combined as a single
parameter, for example Ethernet0/0/1.
Description
Using the display interface command, you can view the configuration
information on the selected interface.
■ Use the command display interface to display information on all ports.
■ Use the command display interface interface_type to display
information on all ports of the specified type.
■ Use the command display interface interface_type interface_number
to display information on a specific port.
Example
To display configuration information on Ethernet port 1/0/1, enter the following:
<SW7700>display interface Ethernet 1/0/1
The information displays in the following format:
Ethernet1/0/1 current state : UP
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc00-0010
Description : aaa
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is
autonegotiation
Flow-control is not supported
The Maximum Frame Length is 1536
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 5 minutes input rate 229 bytes/sec, 2 packets/sec
Last 5 minutes output rate 25 bytes/sec, 0 packets/sec
input: 0 packets, 0 bytes
0 broadcasts, 0 multicasts
input: 0 input errors, 0 runts, 0 giants, 0 throttles, 0 CRC
0 frame, 0 overruns, 0 aborts, 0 ignored, 0 parity errors
Output: 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, 0 underruns, 0 buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, 0 no carrier