Switch 7700 Command reference Guide, v2.0

Ethernet Port Link Aggregation Commands 61
Parameter
start_port_number: Enter the first port in the range of ports that you want to
add to the link aggregation. This becomes the master port in the link aggregation.
end_port_number: Enter the last port in the range of ports that you want to add
to the link aggregation.
both: Enter to configure the sub-ports in the link aggregation to share the
outgoing load on the port, depending on the source address and destination MAC
address.
ingress: Enter to configure the sub-ports in the link aggregation to share the
outgoing load on the port depending on the source MAC addresses. The Switch
7700 does not support ingress aggregation mode.
master_port_number: Enter the master port number in a link aggregation to
cancel the link aggregation.
all: Enter to cancel all aggregated ports.
Description
■ Use the link-aggregation command to add a series of ports to the
aggregation link. The port with the smallest port number is designated the
master port.
■ Use the undo link-aggregation command to cancel a link aggregation, or all
link aggregations.
Note that the Ethernet ports to be added to the aggregated link must all operate
with the same speed and duplex settings. The possible settings are 10 Mbps full
duplex, 100 Mps full duplex, or 1000 Mbps full duplex.
Related command: display link-aggregation.
Example
To configure outgoing load balance on the port depending on the source and
destination MAC addresses, enter the following:
[SW7700]link-aggregation ethernet1/0/1 to ethernet1/0/2 both