Switch 7700 Command reference Guide, v2.0

VLAN Configuration Commands 65
View
All views
Parameter
vlan_id: Enter the ID number of the VLAN interface, ranging from 1 to 4094.
Description
Use the display interface Vlan-interface command to view the information
about a specific VLAN interface, or all VLAN interfaces. The information displayed
includes the current status of the interface, the current status of the line protocol,
the VLAN interface description, the Maximum Transmit Unit (MTU), the IP address
and subnet mask, the format of the IP sending frames, and the MAC hardware
address.
■ Use display interface Vlan-interface to display information on all VLAN
interfaces.
■ Use display interface Vlan-interface vlan_id to display information on
a specific VLAN interface
Related command: interface Vlan-interface.
Example
To display information on VLAN interface 2, enter the following:
<SW7700>display interface vlan-interface 2
The information displays in the following format:
VLAN-Interface2 is up line protocol is up
Description : 3COM, SW7700, VLAN-Interface2 Interface
The Maximum Transmit Unit is 1500
Internet Address is 1.1.1.1/8
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0.fc00.5517
display vlan Syntax
display vlan [ vlan_id | all | static | dynamic ]
View
All views
Parameter
vlan_id: Enter to display information on a specified VLAN.
all: Enter to display information on all VLANs.
static: Enter to display information on VLANs created statically by the system.
dynamic: Enter to display information on VLANs created dynamically by the
system.