Switch 7700 Command reference Guide, v2.0

GARP Configuration Commands 73
Example
To set the Join timer of GARP to 30 centiseconds (300 ms) on port Ethernet 1/0/1,
enter the following:
[SW7700-Ethernet1/0/1]garp timer join 30
garp timer leaveall Syntax
garp timer leaveall timer_value
undo garp timer leaveall
View
System view
Parameter
timer_value: Enter the value of the GARP LeaveAll timer in centiseconds, in the
range 10 to 32765. By default, the LeaveAll timer is set to 1000 centiseconds, that
is 10 seconds.
Description
■ Use the garp timer leaveall command to configure the GARP leaveall timer.
■ Use the undo garp timer leaveall command to restore the default value of
1000 centiseconds.
Related command: display garp timer, garp timer.
Example
To set the GARP LeaveAll timer to 1 second (100 centiseconds), enter the
following:
[SW7700]garp timer leaveall 100
reset garp statistics Syntax
reset garp statistics [ interface interface_type interface_number
[to interface_type interface_number ]]
View
User view
Parameter
interface_type Enter an interface type. This can be either Ethernet or
GigabitEthernet
interface_number: Enter an interface number, in the format
slot-number/subslot-number/port-number. On the Switch 7700 7-slot chassis:
■ The slot number is a number in the range 0 to 6 (the Fabric slot is 0).
■ The subslot number is set to 0.