Switch 7700 Command reference Guide, v2.0

80 CHAPTER 4: USING NETWORK PROTOCOL COMMANDS
■ tcp timer fin-timeout
■ tcp timer syn-timeout
■ tcp window
IP Address
Configuration
Commands
This section describes the commands you can use to configure and manage IP
Addressing on your Switch 7700.
display ip host Syntax
display ip host
View
All views
Parameter
None
Description
Use the display ip host command to display all host names and their
corresponding IP addresses.
Example
To display all host names and their corresponding IP addresses, type the following:
<SW7700>display ip host
The information displays in the following format:
Host Age Flags Address(es)
Host32 0 perm,OK 10.1.1.1
display ip interface
vlan-interface
Syntax
display ip interface vlan-interface vlan_id
View
All views
Parameter
vlan_id: Enter the identifier of the vlan interface.
Description
Using the display ip interface vlan-interface command, you can view the
information on all IP interfaces, or a selected IP interface.
■ Use the display ip interface vlan-interface command to view
information on all IP interfaces.
■ Use the display ip interface vlan-interface vlan_id command to view
information on the specified interface.