Switch 7700 Command reference Guide, v2.0

90 CHAPTER 4: USING NETWORK PROTOCOL COMMANDS
Description
■ Use the dhcp-server ip command to configure the IP address of the DHCP
Server used by the DHCP Server group.
■ Use the undo dhcp-server ip command to delete the IP addresses of all
DHCP Servers in DHCP Server group.
This command has fewer parameters when entered in VLAN interface view. Refer
to dhcp-server for details.
Related commands: dhcp-server, debugging dhcp-relay.
Example
To configure the primary and secondary IP addresses of DHCP Server group 1 as
1.1.1.1 and 2.2.2.2 respectively, enter the following:
[SW7700]dhcp-server 1 ip 1.1.1.1 2.2.2.2
To delete the IP addresses of DHCP Server group1, enter the following:
[SW7700]undo dhcp-server 1
display dhcp-security Syntax
display dhcp-security [ ip_address ]
View
All views
Parameter
ip_address: Enter the client IP address.
Description
■ Use the display dhcp-security command to display information on all
clients.
■ Use the display dhcp-security ip_address command to display
information on a specific client. Use the IP address to identify the client.
Example
To display the IP addresses for each client, enter the following:
<SW7700>display dhcp-security
The information displays in the following format:
IP Address MAC Address Type
2.2.2.2 0005.5d02.f2b2 Static
3.3.3.3 0005.5d02.f2b3 Dynamic