HP ProLiant SL Advanced Power Manager 2.0 Option Installation Instructions

ManualsBrandsHP ManualsComputer AccessoriesHP Apollo a6000 Chassis

HP Advanced Power Manager

Option

Installation Instructions

Overview

This document provides instructions for installing the HP APM. For more

information about the HP APM, see the HP Advanced Power Manager

User Guide on the HP website

(http://www.hp.com/support/APM_UG_en).

Kit contents

Item Description

1 HP APM

2 Mounting brackets (2)

3 Terminal blocks (2)

4 Power cords (2)

5 Bracket mounting screws, T-20 (2)*

6 Rack mounting screws, 10-32 (2)*

7 Cage nuts (2)*

8 This document*

*Not shown

The following cables are required to connect the HP APM to the system:

• Display port cable

• Micro DB9 to DB9 cable or Micro DB9 to Micro DB9 cable

• Ethernet cable

All cables are sold separately.

Important safety information

See the Important Safety Information document included with the

product.

CAUTION: Electrostatic discharge (ESD) can damage

electronic components. Be sure that you are properly

grounded (earthed) before beginning any installation

procedure.

Installation guidelines

• The HP APM can be installed in the front of the rack or in the rear

of the rack. Always install the HP APM with the connectors facing

the outside of the rack.

• If a top-of-the-rack switch is installed, HP recommends that you

install the HP APM behind the top of the rack switch.

Installing the HP APM

1. Install the brackets on each side of the HP APM.

o Front-facing

o Rear-facing

2. Install the terminal blocks on the HP APM.

3. Install the HP APM in the rack. Perform all steps for both

front-facing and rear-facing installation.

The information contained herein is subject to change without notice. The only

warranties for HP products and services are set forth in the express warranty

statements accompanying such products and services. Nothing herein should

be construed as constituting an additional warranty. HP shall not be liable for

technical or editorial errors or omissions contained herein.

Part Number: 755716-002

June 2014

Edition: 2

*755716-002*

755716-002

Summary of content (2 pages)

PAGE 1
HP Advanced Power Manager Option Installation Instructions Installation guidelines Overview This document provides instructions for installing the HP APM. For more information about the HP APM, see the HP Advanced Power Manager User Guide on the HP website (http://www.hp.com/support/APM_UG_en). Kit contents • The HP APM can be installed in the front of the rack or in the rear of the rack. Always install the HP APM with the connectors facing the outside of the rack.
PAGE 2
Connecting the HP APM to the system Depending on the product being connected to the HP APM, the HP APM connects to the system components using various cables. All cables required for connecting the HP APM to the system must be purchased separately. Item Component Connects To 10 Terminal Serial console port on the HP APM 11 RDM • RDM2 or RDM3 port on the HP APM • RDM/HP APM* port on the product chassis *Some products may identify this as the SL-APM port.