Brocade Network Advisor Migration Guide - Supporting Network Advisor 11.1.X (53-1002321-01, May 2011)

42 of 82 Brocade Network Advisor Migration Guide
53-1002321-01
DCFM migration
8. Complete the following steps on the SMI Agent Configuration screen.
a. Enable the SSL by selecting the Enable SSL check box, if necessary.
b. Enter the SMI Agent port number in the SMI Agent Port # field (default is 5989 if SSL Enabled is selected;
otherwise, the default is 5988).
c. Click Next.
9. Select one of the following options on the SAN Network Size screen (for Pure Fabric OS fabrics only) and click
Next:
NOTE
Port count is equal to the total number of switch ports across all fabrics.
• Small (managing up to 2000 switch ports, 1-20 domains)
• Medium (managing up to 5000 switch ports, 21-60 domains)
• Large (managing up to 9000 switch ports, 61-120 domains)
10. Verify your configuration information on the Server Configuration Summary screen and click Next.
11. Complete the following steps on the Start Server screen.
a. Select the Start SMI Agent check box, if necessary.
b. Select the Start SLP check box, if necessary.
c. Click Finish.
After all of the services (SLP and SMI Agent) are started, the configuration wizards closes. You can launch
Network Advisor Server Management Console (Start > Programs > Network Advisor 11.1.X > Server
Management Console) to make changes to the SMI Agent configuration.
NOTE
When migrating from an earlier version of DCFM, you must wait 10 minutes before querying the Network
Advisor SMI Agent because some of the information is not populated until after the next discovery cycle.