.Part 5 Storage Security Best Practices and Support Information HP SAN Design Reference Guide 785355-001

Example 1 Creating and binding consecutive VFC ports
Nexus5010# configure terminal
Nexus5010(config)# interface vfc 1
Nexus5010(config-if)# bind interface ethernet 1/1
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 2
Nexus5010(config-if)# bind interface ethernet 1/2
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 3
Nexus5010(config-if)# bind interface ethernet 1/3
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 4
Nexus5010(config-if)# bind interface ethernet 1/4
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 5
Nexus5010(config-if)# bind interface ethernet 1/5
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 6
Nexus5010(config-if)# bind interface ethernet 1/6
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 7
Nexus5010(config-if)# bind interface ethernet 1/7
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 8
Nexus5010(config-if)# bind interface ethernet 1/8
Nexus5010(config-if)# exit
Nexus5010(config)# interface vfc 1-8
Nexus5010(config-if)# no shutdown
Nexus5010(config-if)# exit
IMPORTANT: Example 2 “Creating and binding nonconsecutive VFC ports” is provided for
reference only. It shows an alternate method of performing this step.
In Example 2 “Creating and binding nonconsecutive VFC ports”, VFC ports 1 through 6, 10,
and 20 through 25 are created, and each VFC port is bound to an Ethernet port. Because
the VFC ports are not sequential, multiple interface vfc commands are required.
FCoE switch configuration quick-setup instructions 399