Installation Guide, Third Edition - Server Expansion Unit

Chapter 2
Installation
Unpacking the Server Expansion Unit
23
Unpacking a Non-Racked Server Expansion Unit
HP recommends the use of a lifter shown in Figure 2-5 such as a RonI Company model 17000 SP 400 lifting
device when moving a non-racked system.
Unloading with a Lifter
Use the following procedure to unload the Server Expansion Unit from the pallet using a lifter.
WARNING Use caution when using a lifter. Because of the weight of the Server Expansion Unit,
it must be centered on the lifter forks before raising it off the pallet to avoid injury.
Never extend more than one server from the same cabinet while installing or
servicing either an Server Expansion Unit or another server product. Failure to
follow these instructions could result in the cabinet tipping over.
Figure 2-5 RonI Lifter
IMPORTANT The Server Expansion Unit must be mounted in the same rack as the server to which it will be
connected. The unit must also be mounted directly above the server in the same rack cabinet.