Manualshelf

Installation Guide, Third Edition - Server Expansion Unit

ManualsBrandsHP ManualsComputer AccessoriesHP BL c-Class SB40c PCI Express Mezzanine Pass Thru Option Kit
31323334353637383940
Chapter 2
Installation
Unpacking the Server Expansion Unit
26
Step 7. Roll the lifter and Server Expansion Unit away from the pallet. Do not raise the Server Expansion
Unit any higher than necessary when moving it over to the rack.
Figure 2-8 Lifting the Server Expansion Unit into Position for Rack Installation
Installing the Cable Management Arm
After the Server Expansion Unit is installed in the rack, the cable management arm (CMA) must be installed
on the rear of the Server Expansion Unit. Follow the instructions for installing the CMA in the installation
guide, hp J1530B, rack integration kit (lower case intended). The CMA is attached to the rack using screws
supplied in the kit. The other end of the CMA is attached to the Server Expansion Unit using custom nuts
supplied in the kit. The installation guide is on the Web at http://www.hp.com/racksolutions
Installing the Rack Interlock Device Assembly
Once the CMA is installed on the rear of the Server Expansion Unit then the interlock device assembly must
be installed. Follow the instructions for installing the interlock device assembly in the installation guide, hp
J1530B, rack integration kit (lower case intended). The installation guide is on the Web at
http://www.hp.com/racksolutions