Installation Guide, Third Edition - Server Expansion Unit

Chapter 4

Cabling and Power Up

HP Integrity rx8620 server and HP 9000 rp8420 server SBA Cable Installation

Connecting SBA Cables to the Server Expansion Unit

Step 1. Remove the top and left side covers from the Server Expansion Unit.

Step 2. Remove the SBA cable bridge bracket, hold-down bracket, and filler plates at the rear of the Server

Expansion Unit in the upper right corner. Discard the parts just removed from the Server

Expansion Unit.

Step 3. Route the SBA cable bundle up to the Server Expansion Unit and then inside the chassis.

Step 4. Insert the SBA cable assembly bracket tab into the corresponding slot in the chassis.

Step 5. Screw the SBA cable assembly bracket attached to the cable bundle into the chassis.

Step 6. Route cables along the outside of the system backplane and match the cables to the connectors

using the REO Cable Instructions label affixed to the chassis.

NOTE The term REO on the REO Cable Instructions label has the same meaning as the

term SBA.

Step 7. Push the cable onto the connector and tighten the screw for each SBA cable to secure the cable in

place to the backplane.