Installation Guide, Third Edition - Server Expansion Unit

Chapter 4

Cabling and Power Up

Voltage Check

This section provides voltage check information for use on the customer site. The emphasis focuses on

measuring the voltages at the power cord plug end specified as an IEC-320 C19 type plug. This is the end that

plugs directly into the back of the Server Expansion Unit chassis.

NOTE These procedures must be performed for each power cord that will be plugged directly into the

back of the Server Expansion Unit. If the expected results from this procedure are not observed

during the voltage check, refer to the next section titled “Voltage Check (Additional

Procedure).”