User Service Guide, Fourth Edition - Server Expansion Unit

Chapter 5

Removal and Replacement

Removing and Replacing a Side Cover

Step 2. Slide the cover back and tilt it away from the chassis.

Figure 5-7 Side Cover Rear Retaining Screw locations

Replacing a Side Cover

Step 1. If the side cover is to be replaced, visually inspect the replacement part for proper number and

revision.

Step 2. Hold the cover at a slight angle away from the rear of the unit. Then, after ensuring that the

intrusion switch is clear, start the front edge of the cover into its slot. Carefully push the cover

against the side of the unit and slide it toward the front, into position. Ensure that the rear cover

screw hole aligns with the chassis rear screw hole.

Step 3. The cover easily slides into position; however, a slow firm pressure is needed to properly seat it.

Step 4. Tighten the blue cover retaining screw on the rear of the chassis.