User Service Guide, Fourth Edition - Server Expansion Unit

Chapter 5

Removal and Replacement

Removing and Replacing a Bulk Power Supply (BPS)

Replacing a BPS

Step 1. Verify that the locking lever is on the inside of the component, then insert the BPS into the empty

slot and slide it all the way in.

NOTE The BPS easily slides into the chassis; however, a slow, firm pressure will be needed

to properly seat the connection.

Step 2. You will know that the BPS has seated by the clicking sound made by the locking lever.

NOTE The BPS LED should show that the BPS is operational and there is no fault. The

BPS LED should be GREEN.