User Service Guide, Fourth Edition - Server Expansion Unit

Chapter 5
Removal and Replacement
Removing and Replacing a PCI Power Supply (Brick)
64
Replacing a PCI Power Supply (Brick)
Step 1. Carefully align and push the power supply in the chassis until the thumb latch catches.
Step 2. The module easily slides into the chassis; however, a slow firm pressure is needed to properly seat
the connection.
Step 3. Replace the bezel.
Step 4. Power on the system. Use PE and PS commands to confirm success.
Step 5. Note status of Power Supply LEDs. The green power LED should be ON and the fault amber or red
LED should be OFF.