HP Integrity BL860c Server Blade Installation Guide

Figure 3 Removing the Server Blade Access Panel
After the access panel is off, you can do the following:
• Add an additional processor.
See “Installing a Processor” (page 13).
• Add additional memory DIMMs.
See “Installing DIMMs” (page 15).
• Add additional mezzanine cards.
See “Installing Mezzanine Cards” (page 16)
Installing a Processor
Use this procedure to install an additional processor into the server blade.
To install a processor:
1. Remove the dust cover from the empty processor 1 slot on the system board (if necessary).
2. Make sure the ZIF socket lock for the empty processor 1 slot on the system board is unlocked
by turning the cam counter-clockwise 180 degrees with the processor installation tool (1).
If the socket lock does not turn, the socket is open and ready for the processor to be installed.
Figure 4 shows the ZIF socket lock in the unlocked position.
Installing Additional Components 13