HP BladeSystem c3000 Enclosure and c3000 Tower Enclosure Maintenance and Service Guide

Removal and replacement procedures 35
o
Full-height blade
CAUTION: For best cooling practices, do not operate the enclosure for extended periods with
more than one component or blank removed. When removing an active component, replace it
with a blank.
To replace the component, reverse the removal procedure.
Device bay divider
To remove the component:
1. Remove any components in the device bays:
o Device bay blank (on page 33)
o Half-height or full-height blade (on page 34)
2. Slide the locking tab down.