HP BladeSystem c3000 Enclosure and c3000 Tower Enclosure Maintenance and Service Guide

Removal and replacement procedures 47
10.
Remove the media board assembly cable.
11. Remove the four T-15 Torx screws securing the media board assembly to the front cage.
12. Remove the media board assembly.
To replace the component, reverse the removal procedure.
Media board (SATA DVD drive model)
To remove the component:
1. Power down the server blades or workstation blades (on page 30).
2. Power down the storage blades, if applicable ("Storage and other partner blade power" on page 31).
3. Power down the enclosure ("Powering down the enclosure" on page 31).
4. Remove all half-height and full-height blades ("Half-height or full-height blade" on page 34).