HP BladeSystem c3000 Enclosure and c3000 Tower Enclosure Maintenance and Service Guide

Removal and replacement procedures 52
Bottom bezels (c3000 tower enclosure)
To remove the component:
1. Power down the server blades or workstation blades (on page 30).
2. Power down the storage blades, if applicable ("Storage and other partner blade power" on page 31).
3. Power down the enclosure ("Powering down the enclosure" on page 31).
WARNING: To reduce the risk of personal injury or equipment damage, at least two people are
needed to safely move the enclosure or the front cage.
4. Remove the three T-15 Torx screws that secure the bezel.
5. Remove the bezel.
To replace the component, reverse the removal procedure.
Security panels (c3000 tower enclosure)
To remove the component:
1. Close the HP BladeSystem Insight Display.
2. Unlock the front security panel.