HP BladeSystem c3000 Enclosure and c3000 Tower Enclosure Maintenance and Service Guide

Removal and replacement procedures 53
3.
Lift up on the front security panel, and then remove it from the enclosure.
4. Disconnect all cables from the rear of the enclosure.
5. Unlock the rear security panel.
6. Lift up on the rear security panel and remove it from the enclosure.
To replace the components, reverse the removal procedure.
Casters (c3000 tower enclosure)
To remove the component:
1. Power down the server blades or workstation blades (on page 30).
2. Power down the storage blades, if applicable ("Storage and other partner blade power" on page 31).
3. Power down the enclosure ("Powering down the enclosure" on page 31).