HP BladeSystem c3000 Enclosure and c3000 Tower Enclosure Maintenance and Service Guide

Removal and replacement procedures 54
WARNING: To reduce the risk of personal injury or equipment damage, at least two people are
needed to safely move the enclosure or the front cage.
4. Remove the three T-15 Torx screws securing the caster to the bottom of the enclosure.
5. Remove the caster.
To replace the component, reverse the removal procedure.
Hot-plug power supply or power supply blank
IMPORTANT: If you are servicing a c3000 tower enclosure with the optional security panels
installed, these security panels must be removed before beginning this procedure.
To remove the component:
CAUTION: This procedure provides instructions for replacement of a failed part only. To change
the configuration of components, see the appropriate HP BladeSystem c-Class enclosure setup
and installation guide.
1. Press the release button.