HP BladeSystem c3000 Enclosure and c3000 Tower Enclosure Maintenance and Service Guide

Removal and replacement procedures 56
NOTE: When installing a fan in the top row of fan bays, orient the fan so that the LED is in the
lower right corner. When installing a fan in the bottom row of fan bays, orient the fan so the LED
is in the upper left corner.
NOTE: You cannot install HP Active Cool 100 fans and HP Active Cool 200 fans in the same
enclosure. The Onboard Administrator sends an error message, and you must remove the type of
fan with the least number of units installed.
Active Cool 100 fan
To remove a fan, press up on the lever, and pull the fan out of the enclosure.
To replace the component, slide the component into the bay until it clicks.
NOTE: You cannot install HP Active Cool 100 fans and HP Active Cool 200 fans in the same
enclosure. The Onboard Administrator sends an error message, and you must remove the type of
fan with the least number of units installed.
NOTE: When installing a fan in the top row of fan bays, orient the fan so that the LED is in the
lower right corner. When installing a fan in the bottom row of fan bays, orient the fan so the LED
is in the upper left corner.
Interconnect blank
To remove the component:
1. Press the release tabs.