HP BladeSystem c3000 Enclosure and c3000 Tower Enclosure Maintenance and Service Guide

Removal and replacement procedures 60
KVM module
1. Disconnect all cables from the KVM module.
2. Press the tab, and then pull the KVM module from the enclosure.
To replace the component, reverse the removal procedure.
c3000 tower enclosure dust filter
To install the dust filters:
1. Line up the dust filter with the notch on the Insight Display pocket in the front security panel.
2. Snap the dust filter into place.
3. Repeat steps 1 and 2 on the bottom half of the front security panel, using the second dust filter.
To remove the dust filters: