HP BladeSystem c3000 Tower Enclosure Quick Setup Instructions

Setting up the enclosure
1. Select the proper location for the enclosure to be set up based
on requirements detailed in the HP BladeSystem c3000 Tower
Enclosure Setup and Installation Guide.
2. Remove the packing materials from the pallet.
3. Unlock the enclosure wheels.
4. Roll the enclosure down the pallet ramp, and place in the
location selected in step 1.
Enclosure bay identification
Before installing front or rear components into the enclosure, review
enclosure bay numbering for each component.
Full-height device bay numbering
Half-height device bay numbering
Power supply bay numbering
Fan bay numbering
Installing the front components
CAUTION: To prevent improper cooling and thermal
damage, do not operate the blade or the enclosure unless
all hard drive and device bays are populated with either a
component or a blank.
1. If necessary, slide the Onboard Administrator module into the
bay. When fully inserted, the module locks into place.
2. Access the Insight Display.
a. Press and release the panel to access the Insight Display.