HP BladeSystem c3000 Tower Enclosure Setup and Installation Guide

Identifying components and LEDs 14
Item Description Status
1 Reset button —
2 USB connector —
3 Health LED Green = Normal
Red = OA firmware issue. See the HP
Onboard Administrator User Guide on the HP
website
(http://www.hp.com/go/bladesystem/docum
entation).
4 Active LED Green = Primary OA module
Off = Standby OA module
5 UID LED Blue = Activated
Off = Deactivated
6 Serial connector —
Enclosure rear components
Item Description
1 Reserved for future use
2 Interconnect bay 1
3 Fan bays ("Fan bay numbering" on page 15)
4 Interconnect bay 2
5 Enclosure link-down port
6 Enclosure link-up port
7 Onboard Administrator 1/iLO port
8 Optional KVM module bay
9 Power supply bays ("Power supply bay numbering" on
page 16)