HP BladeSystem c3000 Tower Enclosure Setup and Installation Guide

Installing components 18
Installing components
Setting up the enclosure
1. Select the proper location for the enclosure to be set up based on requirements detailed in "Planning
the installation (on page 5)."
2. Remove the packing materials from the pallet.
WARNING: To reduce the risk of personal injury or damage to the equipment in a rack-free
environment:
• Never stack an enclosure on top of another enclosure.
• Never place equipment on top of an enclosure.
• Never place an enclosure on a surface that cannot support up to 153.7 kg (338.9 lb).
3. Unlock the enclosure wheels.
4. Roll the enclosure down the pallet ramp, and then place it in the location selected in step 1.
5. Lock the enclosure wheels.
Component installation
The following sections contain installation instructions for the individual enclosure components. All
components must be installed and cabled before you power up the enclosure. There is no specific
installation order requirement for the enclosure components.