HP BladeSystem c3000 Tower Enclosure Setup and Installation Guide

Installing components 24
3.
For the half-height divider, push the divider toward the back of the enclosure until the divider stops.
Push the divider up to disengage the tabs from the divider wall, and then rotate the divider
clockwise.
For the mini divider, push the divider toward the back of the enclosure, and then slide it to the left.
Pull the divider out of the chassis.
4. Remove the device bay divider from the enclosure.
Creating a full-height device bay blank
1. Obtain the coupler plate:
o If you are using a device bay blank that came with the enclosure, the coupler plate can be found
with the contents of the full-height device shipping box.
o If you are using a device bay blank that you purchased as an option, remove the coupler plate
from inside the blank.