HP BladeSystem c3000 Tower Enclosure Setup and Installation Guide

Installing components 27
Installing dividers
You must install dividers to support half-height devices. The half-height divider adds support for four
adjacent half-height devices. The mini divider adds support for two half-height and one full-height
adjacent devices.
1. Remove the full-height blade, storage blade, or device bay blank.
2. Install the mini divider (proceed to step 3 to install the half-height divider):
a. Align the three tabs on the edge of the mini divider with the openings in the enclosure, and then
slide the mini divider straight back.
b. Push the mini divider to the right, and then pull it forward until it stops.