HP BladeSystem c3000 Tower Enclosure Setup and Installation Guide

Installing components 40
Interconnect bay crosslinks
Interconnect bay crosslinks are wired between adjacent interconnect bay pairs.
You can enable these crosslinks to provide module-to-module connections. The Onboard Administrator
disables the interconnect bay crosslinks in instances where the crosslinks cannot be used, such as when
two different modules reside in adjacent horizontal interconnect bays.
Removing interconnect bay dividers
The enclosure ships with interconnect bay dividers installed. The interconnect bay dividers must be
removed before installing double-wide interconnect modules. To remove an interconnect bay divider,
press the release tab, and pull the interconnect bay divider out of the enclosure.
Installing interconnect bay dividers
The enclosure ships with interconnect bay dividers installed. The interconnect bay dividers must be
installed to use single-wide interconnect modules.