HP BladeSystem c3000 Tower Enclosure Setup and Installation Guide

Using the HP BladeSystem Insight Display 50
DVD Drive—The default setting is Detached on all blades. To connect any blade to a CD or DVD
disk inserted into the enclosure DVD that is plugged into the Onboard Administrator or included in
the enclosure, navigate to Connect and press OK. The following selections are valid on the DVD
Connection Settings menu:
o Detach/Attach—Each server can be individually attached to or detached from the enclosure DVD
drive by navigating to that bay and pressing the OK button.
o Change—Navigates to the Attach:Enclosure DVD menu where you can attach, attach and
reboot, or detach all bays from the DVD drive.
o Attach—Attaches the enclosure DVD to all blades.
o Attach and Reboot Svr—Attaches the enclosure DVD to all blades, then reboots all blades.
o Detach—Detaches the enclosure DVD from all blades.
Insight Display PIN#—The default setting is Not Set. HP recommends that you set a PIN to protect the
enclosure configuration from unauthorized changes. You must enter the PIN after each inactivity
period to change options in the Enclosure Settings menu. The accepted character values are 0–9, A–
Z, a–z, -, _ and
. is used to signal the end of the name.
5. Navigate to the Accept All button at the bottom of the Enclosure Settings screen, and press the OK
button to accept all the settings and continue.
6. In the Check: Linked Enclosures screen, the message "Linked enclosures detected" displays if the
Onboard Administrator module detects other enclosures. Use the up and down arrow buttons to
change Push Settings = to one of the following values: