HP BladeSystem Onboard Administrator User Guide

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 114
Forced settings take effect 3 seconds after enabling or disabling the settings. The forced option only
supports NIC speeds of 10Mbps or 100Mb/s.
• NIC Speed—Selects a NIC speed of 10Mb/s or 100Mb/s
To save the new settings, click Apply.
Advanced Settings tab
This screen displays the current enclosure TCP/IP settings (Advanced settings) for the Active Onboard
Administrator. The Advanced Settings tab allows you to enable or disable the DHCP-Supplied Domain Name
option and to input User-Supplied Domain Names for both Active and Standby if the DHCP-Supplied Domain
Name option is disabled. To enable or disable the DHCP-Supplied Domain Name option, or to set
User-Supplied Domain Names, Dynamic DNS must be enabled. To enable Dynamic DNS, use the IPv4
Settings tab (on page 108) or the IPv6 Settings tab (on page 110).
To override the DHCP-supplied domain name manually, clear the Use DHCP-Supplied Domain Name check
box, and then enter the domain name. Click Apply.
NOTE: When the Use DHCP-Supplied Domain Name check box is selected, you cannot edit the
domain name field.
Network Access